Maytag AOCS3040 Manual do Utilizador descarregar pdf (Página 7)

Jenn-Air, Maytag and Magic Chef Fault Codes

WARNING

To avoid risk of electrical shock, personal injury or death; disconnect power and gas supply to oven before

servicing, unless testing requires power and/or gas.

16023509 7

PRODUCT(S): FREESTANDING RANGES, ACCELLIS 2X

MODELS: MER6750AA*, MER6750AC*

Fault

Code

Problem Component(s) to Check

F0-0 No Fault........................................................................ None.

F1-1 Oven temperature above 650˚ F when bake/broiling... Check door lock, oven sensor, and harness.

If ok, replace control.

F1-3 Oven temperature above 905˚ F during clean cycle.... Check door lock, oven sensor, and harness.

If ok, replace control.

F1-5 Cancel key not responding .......................................... Ensure ribbon is making good connection and

inspect ribbon. If ok, replace control.

F1-7 Membrane disconnected.............................................. Ensure ribbon is making good connection and

inspect ribbon. If ok, replace control.

F1-8 Shorted key in membrane switch................................. Ensure ribbon is making good connection and

inspect ribbon. If ok, replace control.

F1-9 Slave microprocessor not functioning .......................... Replace control.

F1-A Control does not see state of lock or unlock switches . Check connections on the door lock assembly,

check lock switch with meter, check wiring from

assembly to control.

F1-C Door switch is not recognized as opened or closed .... Check connections at door switch, check lock

mechanism, check wiring from switch to control.

F1-E Control not calibrated ................................................... Replace control.

F1-F Jumper not removed from PCB ................................... Replace control.

F1-H EEPROM error ............................................................. Replace control.

F1-N Microprocessor voltage error ....................................... Replace control.

F3-1 Sensor is shorted or open ............................................ Ohm sensor and harness.

DO NOT REPLACE CONTROL.

F9-1 Door lock will not lock................................................... Check wire connections.

If ok, replace motorized door lock.

F9-2 Door lock will not unlock............................................... Check wire connections.

If ok, replace motorized door lock.

F9-3 Door lock is locked and unlocked at the same time..... Check wire connections.

If ok, replace motorized door lock.

1 2 3 4 5 6 7 8 9 10 11 12 ... 18 19

Sem comentários

Maytag AOCS3040 Manual do Utilizador Página 7