Maytag AOCS3040 Manual do Utilizador descarregar pdf (Página 13)

Amana, Caloric and Modern Maid Fault Codes

WARNING

To avoid risk of electrical shock, personal injury or death; disconnect power and gas supply to oven before

servicing, unless testing requires power and/or gas.

16023509 13

PRODUCT(S): FREESTANDING RANGES, FLORENCE FACILITY, EMPLOYING SIGMA

ELECTRONIC RANGE CONTROL (ERC) WITH TOUCHMATIC CONTROL

MODEL(S): AMANA BRANDS

Oven Temperature Calibration:

1) Press BAKE pad.

2) Set oven temperature to 500° F.

3) Press and hold BAKE pad until offset temperature displays.

4) To increase of decrease temperature, press BAKE pad until desired offset temperature displays.

NOTE: Offset temperature is wrap-around function.

5) Adjust +35° F to -35° F in 5° increments.

6) Press START to lock offset temperature.

NOTE: Offset temperature is retained through power failures.

Child Lock-Out:

1) Press 7 pad for 3 seconds to activate.

2) Press 7 pad for 3 seconds to deactivate.

Sabbath Mode:

1) Press BAKE pad.

2) Enter oven temperature.

3) Press START.

NOTE: Turn on oven light, if desired.

4) Press and hold 8 pad for 3 seconds to activate Sabbath mode.

NOTE: Sabbath mode activates for 37 hours, unless cancelled.

Fault

Code

Problem Component(s) to Check

F0-0 Initial factory setting ................................................ None.

F1-1 Over temperature in cook mode ............................. Ohm sensor, 1100 at room temperature, and

check wiring.

F1-3 Over temperature in clean cycle ............................. Ohm sensor, 1100 at room temperature, and

check wiring.

F1-5 Cancel key input out of range ................................. Replace control.

F1-7 Keyboard disconnected........................................... Verify connections.

F1-8 Shorted key ............................................................. Replace control.

F1-9 Slave micro not functioning..................................... Replace control.

F1-A VCC/ground lift off................................................... Replace control.

F1-E EEPROM data corrupt ............................................ Replace control.

F1-F Incorrect project number in EEPROM..................... Replace control.

F1-H Door switch input circuit failure ............................... Check door switch and wiring.

F1-J Latch switch input circuit failure .............................. Check door switch and wiring.

F3-1 Sensor/Sensor Circuit failure .................................. Check sensor and wiring.

F9-1 Auto latch will not lock............................................. Check wiring, latch motor, latch and door switch.

F9-2 Auto latch will not unlock......................................... Check wiring, latch motor, latch door switch.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 19

Comentários a estes Manuais

Sem comentários

Maytag AOCS3040 Manual do Utilizador Página 13

Comentários a estes Manuais

Manuais e produtos relacionados com Fornos Maytag AOCS3040