Maytag LAT9356AAE Guia do Utilizador descarregar pdf

Read this before you start…

TOOLS needed for installation:

• Cutting knife

• Channel lock

• Nut driver

• Level

• Crescent wrench

• Screwdriver-flatblade

Proper installation is the responsibility of the purchaser.

SERVICE CALLS PERFORMED AS A RESULT OF POOR INSTALLATION ARE THE

RESPONSIBILITY OF THE INSTALLER.

Make sure you have everything necessary for proper installation.

GROUNDED ELECTRICAL OUTLET is required. See Electrical Requirements.

STANDPIPE DRAIN SYSTEM must be able to accept 1 1/2” O.D. drain hose. Standpipe

height of 36” is recommended.

NOTE: Unit is designed to pump efficiently to a height of 8 feet at normal spin speeds.

HOT AND COLD WATER FAUCETS must be within 4 feet of the back of the washer.

LAUNDRY TUB DRAIN SYSTEMS (for use with Water-Saver Models only). Tub capacity

to hold a minimum of 21 gallons.

WATER HEATER set to deliver 140°F (60°C) hot water to the washer.

PROTECTION FROM WEATHER: Do not store or operate washer below 60°F (15°C).

PARTS supplied for installation:

• 2 inlet hoses

• 4 hose washers

• 2 hose screens

• 1 cable tie

• Literature package

INSTALLATION ACCESSORY KITS

Part No. Description Application

12001875 Grounding Kit Additional grounding if required by local codes.

12001585 Drain Hose Extension Extends drain hose for drain facilities higher than 4 ft.

12001586 Anti-Siphon Used when an air-tight connection exists between

drain hose and drain facility. Floor drain facilities.

12001599 Small Diameter Standpipe Used when standpipe diameter is too small to

Drain Hose receive end of drain hose.

211692 Non-Slip Disc For painted /sloped basement floors.

204986 Carpet Installation Disc For carpeted floors.

1 2 3 4 5 6

Resumo do Conteúdo

Página 1 - INSTALLATION ACCESSORY KITS

Read this before you start…TOOLS needed for installation:• Cutting knife• Channel lock• Nut driver• Level• Crescent wrench• Screwdriver-flatbladePrope

Página 2 - REQUIREMENTS

AUTOMATIC WASHERINSTALLATION INSTRUCTIONSLEAVE INSTALLATION INSTRUCTIONS ANDUSER’S GUIDE WITH THE OWNERPrinted in U.S.A. 6 2305670ELECTRICAL120 Volt 6

Página 3

CABINET DIMENSIONSDRAIN FACILITYRecommended height of standpipe is 36”. Ifthe standpipe is less than 36” high, the drainhose should be routed through

Página 4

STEP 2• Lay two carton corner posts on the floor.• Make sure one corner post is placed againstthe wooden crate bottom.• Tip washer forward on its fron

Página 5 - Step 10b

CLIPSTEP 9STANDARD MODELS36” standpipe recommended• If standpipe is less than 36” (or floor drain) –drain hose should be routed through the clipto rai

Página 6

CHECK LIST Tub block, accessory package andinstructions have been removed fromtub. Washer is properly grounded andplugged into a polarized electric